-140 -130 -120 -110 -100 -90 -80 -70 1000 10000 100000 V580ME16-LF basestations portable radios mobile communications 5 15 43 830 0.5-4.5 54 -109 -12 <1 <3 50 50 -30 to 80 oscillation frequency range phase noise @ 10 khz offset (1 hz bw, typ.) harmonic suppression (2nd, typ.) tuning voltage tuning sensitivity (avg.) power output load impedance input capacitance (max.) pushing pulling (14 db return loss, any phase) operating temperature range package style mini-16-l mhz dbc/hz dbc vdc mhz/v dbm pf mhz/v mhz c vdc ma supply voltage (vcc, nom.) supply current (icc, typ.) all specifications are typical unless other wise noted and subject to change without notice. phase noise (1 hz bw, typical) ? z-communications, inc. all rights reserved page 1 voltage controlled oscillator features applications performance specifications value units power supply requirements application notes 830 970 - mhz ? frequency range: ? tuning voltage: 0.5-4.5 vdc - style package mini-16-l ? ? ? ? a1 rev ? an-100/1 : mounting and grounding of vcos ? an-102 : proper output loading of vcos ? an-107 : how to solder z-comm vcos notes: 9939 via pasar ? san diego, ca 92126 tel (858) 621-2700 fax (858) 621-2722 - 970 offset (hz) (f) (dbc/hz)
750 775 800 825 850 875 900 925 950 975 1000 00.511.522.533.544.5 -1 0 1 2 3 4 5 6 771 797 822 847 874 901 928 951 968 984 low cost - high performance voltage controlled oscillator ? z-communications, inc. page 2 printed in the u.s.a. V580ME16-LF tuning curve, typ. power curve, typ. page 2 physical dimensions c c c 80 -30 25 c 25 0.475 0.000 0.025 0.500 0.405 0.305 0.205 0.105 0.185 0.285 0.385 0.500 0.115 0.215 0.315 0.415 0.420 0.320 0.475 0.500 0.000 0.025 0.220 ground plane solder plated bottom view p1 p3 p2 .037 see note 3 typical of all pads .026 .031 .052 .114 .070 0.085 0.115 tabs range: see note 5. (4 places) detail a p1=vt p2=rf out p3=vcc .130 .034 0.000 -.005 .465 .070 typ .150 typ mini-16-l 415-0061 rev. d (drawing not to scale) see detail 'a' notes: the inside radius of all 16 half holes at the perimeter of the board are plated to provide a surface for the attachment of the vco to a pcb, in 13 locations, with 3 pads being used for electromechanical interface. 2. the surface of the shield is tin plated and may be soldered to. the shield's 3. the ground plane is ground and attaches to a ground track on the upper side of the board as well as the shield by pth. 1. 16 solder locations required. base metal is cold rolled steel. .xxx= .010 tolerances 4. unless otherwise noted all dimensions are in inches. 5. unless otherwise noted all tolerances are as follows: tuning voltage (vdc) frequency (mhz) power output (dbm) frequency (mhz)
|
